System Reset
Following initial AD1024 system installation or a major re-
configuration of the switching system, it may be necessary to
clear all programmed information from the AD1024 CPU, and
reset the system to factory defaults.
User-programmed data is stored in memory and is battery-
backed for a minimum of five years. The data stored includes
date/time, input identification, system tours, system salvos,
event timers, port configurations, system partitioning, and
alarm programming information. System Reset clears this
stored information from the LOCAL AD1024 CPU.
CAUTION - THE FOLLOWING COMMANDS ERASE
ALL USER ENTERED DATA.
Note: System Reset is accessible from the AD2088 keyboard,
or the AD5400 or AD5500 Excalibur system only.
To clear and reset LOCAL AD1024 CPU programming:
1. Turn the keyboard keyswitch to the PROG position.
2. Enter the following keyboard F2 code combination:
“55 F2” (Enter the number 55, then press the F2 key.)
3. Within three seconds, enter the following keyboard F2
code combination:
“99 F2” (Enter the number 99, then press the F2 key.)
Note: A built-in safety feature requires entering the “99 F2”
command within three seconds of the “55 F2” command.
If “99 F2” is not entered within the required three seconds,
the system will not clear and reset.
When this combination of keys is entered, the LOCAL
AD1024 clears and resets all user programmed data (Tours,
Salvos, Alarm Programming, Event Timers, etc.). This reset
has no affect on the programming at REMOTE Sites in a
network. System Reset resets the LOCAL AD1024
programmed functions to the factory default settings.
Refer to the Appendix, page A-2, for the factory default
settings of all programmed information.
Operating System Software Verification
When calling American Dynamics for assistance, the revision
level of the AD1024 CPU software may require verification.
Note: Operating System Software can be verified from the
AD2088 keyboard, or the AD5400 or AD5500 Excalibur
system only.
To verify the LOCAL AD1024 CPU operating system:
1. Power up the AD1024 CPU with a keyboard connected
to one of the control ports, and at least one monitor and
one camera input connected to the switching system.
2. Enter the monitor number on the keypad.
3. Press the keyboard MONITOR button.
4. Enter the camera number on the keypad.
Note: A proper video source must be connected to this
camera input.
5. Press the keyboard CAMERA button.
6. Turn the keyboard keyswitch to the PROG position.
7. Enter the following keyboard F2 code combinations:
“70 F2” (Enter the number 70, then press the F2 key.)
In response, a 5-digit code, “UFaaa”, is shown in the Status
Line of the on-screen display (Figure 2-1, page 2-3). The last
digits of this display code identifies the revision level of the
LOCAL AD1024 CPU Operating System.
1-3
AD1024 SYSTEM OPERATION
IF YOU ENCOUNTER ANY PROBLEMS
OPERATING THIS UNIT, OR NEED ASSISTANCE,
CALL OUR TECHNICAL SUPPORT CENTER:
within the United States: 1-800-442-2225
outside the United States: (845) 624-7640
(96 Seiten)
(264 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern