American Dynamics RAS918LSP Spezifikationen PDF herunterladen (Seite 13)

SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME 8200-0184-14, REV. A

INSTALLATION AND SERVICE GUIDE

13 of 37

4. For the dome at the end of a daisy chain, set

termination jumper JW1 on the dome CPU

board (

Figure 13) to “terminated.”

Position of dome in

communications line… Setting Pins

Between other devices Unterminated 1-2*

End of communications line Terminated 2-3

* Pins 1-2 are closest to 9-pin connector.

Note: You may need a small slotted screwdriver

to gently pry the jumper loose. Be careful not to

damage the underlying PC board.

Figure 13. Video cable connection and

termination jumper location

5. Connect the 9-pin plug (data and power) to the

9-pin receptacle (

Figure 14). If using a Pelco

Coaxitron or Panasonic UTC protocol, no data

wires are connected, just power.

CAUTION: DO NOT connect the 9-pin plug

unless you have performed step 3 first!

a. Feed cables through the access hole in the

base.

b. Connect data and power wires to the 9-pin

plug (refer to charts below).

c. Insert the plug into the mating receptacle in

the top of housing and eyeball assembly.

Manchester data and power connections.

Order data cable 88760 (plenum) or 8760

(non-plenum) from Belden by calling

1-800-235-3361.

Pin Color Designation

1 White Manchester (–)

2 Black Manchester (+)

3 Black 24Vac

4 Red Ground

5 White 24vac

6-9 — Not used.

RS-422/Pelco P data and power connections

Pin Color Designation

1-2 — Not used.

3 Black 24Vac

4 Red Ground

5 White 24Vac

6 Orange RS-422 Data In High (+)

7 Green RS-422 Data In Low (–)

8 Yellow RS-422 Data Out High (+)

9 Brown RS-422 Data Out Low (–)

SensorNet data and power connections

Pin Color Designation

1 Orange SensorNet (unshielded)

2 Yellow SensorNet (unshielded)

3 Black 24Vac

4 Red Ground

5 White 24Vac

6-9 — Not used.

Termination

Jum

p

er JW1

Micro

Coax

Cable

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

Kommentare zu diesen Handbüchern

Keine Kommentare