American Dynamics RAS916LS-1 Spezifikationen PDF herunterladen (Seite 29)

SPEEDDOME ULTRA VII AND ULTRA VIIE CAMERA DOME 8200-0184-01, REV. E

INSTALLATION AND SERVICE GUIDE

29 of 38

6. Access tilt motor.

To do this, loosen captive retaining screw

holding tilt cable assembly in place and gently

remove this assembly.

7. Remove tilt motor (

Figure 36).

Lift motor housing up as shown to disengage

motor from tilt gear. Then pull motor bracket

towards outside of cable/tilt assembly to remove

motor.

Figure 36. Removing the tilt motor

8. Reverse steps to reassemble.

CAUTION: When installing a new motor, be

careful to properly mesh motor and tilt gears!

Failure to do so can destroy both motor and tilt

gear. Verify tilt gear turns freely!

Updating/Reprogramming

Dome Software

CAUTION: This procedure involves extracting a

flash memory chip, an electrostatic-sensitive

device. Use a ground strap when handling the chip.

To update or reprogram dome software:

1. Insert the chip extractor tool into the square

access hole and squeeze the tool to extract the

flash memory chip (

Figure 37).

2. Reprogram the chip or replace it with a new

one.

3. Align the dot on the chip with the indent on the

socket; then push down on the chip to reinsert

it.

Figure 37. Removing the flash memory chip

Tilt Motor

(Lift up, then out.)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Keine Kommentare

American Dynamics RAS916LS-1 Spezifikationen Seite 29