American Dynamics RAS916LS-1 Spezifikationen PDF herunterladen (Seite 24)

SPEEDDOME ULTRA VII AND ULTRA VIIE CAMERA DOME 8200-0184-01, REV. E

INSTALLATION AND SERVICE GUIDE

24 of 38

Disassembling the Dome

CAUTION: Once disassembled, parts of dome

housing and eyeball assembly are "extremely

fragile" and may break. Use extreme care!

This section explains how to remove the following

parts from the camera dome.

• CPU board, page

• Power supply, page

• Pan motor, page

• Slot covers, page

• Camera, page

• Eyeball, page

• Camera/Lens board, page

• Tilt motor, page

28.

This section also explains how to update and

reprogram dome software (Page

29).

To order parts (authorized users only),

see page

30.

Tools Required

• Phillips-head screwdriver.

• Small slotted screwdriver.

Removing the CPU Board

CAUTION: Electrostatic-sensitive device. Use a

ground strap when handling CPU board.

Referring to

Figure 23.

1. Remove cap.

Remove three Phillips-head screws holding cap,

then "gently" lift cap to one side.

2. Detach connectors.

On CPU board, detach 8-pin power supply

cable from connector P1, pan motor cable from

connector P8, and 14-pin slip ring cable from

connector P2.

3. Remove CPU board.

Push your finger through large finger connector

hole in cap to pop out CPU board.

4. Reverse steps to reassemble.

CAUTION: Do not to pinch wires! When

inserting CPU board into housing, avoid

pinching power supply cable wires against

standoffs.

Figure 23. Removing the CPU board

Metal fingers of

ribbon cable must

face contacts of

connector.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare

American Dynamics RAS916LS-1 Spezifikationen Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitskameras American Dynamics RAS916LS-1