American-dynamics MegaPower CPU ADMPCPU Bedienungsanleitung PDF herunterladen (Seite 21)

MEGAPOWER CPU 8200-0421-02, REV. E

OPERATOR’S GUIDE

19 of 21

Function Actions

Control Tour

Press Next or Last to change direction (forward or reverse) for executing a tour

Press Hold to hold a tour

Press Run to restart a tour

Press Next or Last to manually step through the cameras of a tour that is on hold

Call Salvo -Call first monitor in group -enter Salvo # -press Salvo

Acknowledge Alarm -Call alarming monitor -press Ack

Control Auxiliary -Call camera -specify the Auxiliary number (1–4)

(1)

-press Auxiliary On or

Auxiliary Off to turn an auxiliary on or off

Note:

Pressing Auxiliary On or Off without specifying the number activates the previously

specified Aux number.

View Satellite Sites -Call local monitor # -enter site # -press Site -call remote camera #

Disconnect/Log Off

Satellite

-Press Site -call local camera

DirectSet

(SensorNet only)

• -Press Hold only to display or close the DirectSet menu when not running a

tour or attached to an alarming monitor, or

• -Enter 0 -press Hold to display or close the DirectSet menu, or

• -Enter a number -press Hold to select a DirectSet menu command whether

or not the menu is displayed

Note:

All SpeedDome Optima camera domes can receive DirectSet commands, but do

not display the menus.

Note:

(1)

Auxiliary 4 is not supported by all dome/PTZ protocols and configurations.

Programming Functions

Note: The following functions can only be performed with the keyboard in Program (P) mode, indicated by a

“P” displayed in the lower right of the LCD. Enter P mode before starting the step sequence listed for each

function.

To enter P mode from a locked (L) state, enter your password and press Lock. If you need to obtain the

password, please contact your system administrator.

Function Action

Program Presets

-Call monitor and camera -press + -move camera to position -enter

Preset # -press Preset Enter (or Shot Enter) -press – (minus)

Program Patterns

-Call monitor and camera -enter Pattern # -press Pattern -press Prog

-maneuver camera -press Ack

Clear Patterns

(RS-422 only)

-Call camera -enter Pattern # -press Pattern -press Clear

Program Monitor Tours

-Call monitor -enter 62 -press Prog -enter camera # -press

CAMERA -enter dwell time (1-60) -press Prog -repeat steps 4–7 for all

subsequent cameras in tour (up to a maximum of 64 entries) -press Run

Arm Monitor -Call monitor -enter arming type ID # (301–315) -press F2

Disarm Monitor -Call monitor -enter 316 -press F2

Display Current

Monitor Arming Type

-Call monitor -enter 300 -press F2

1 2 ... 16 17 18 19 20 21 22 23 24 25

Kommentare zu diesen Handbüchern

Keine Kommentare

American-dynamics MegaPower CPU ADMPCPU Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern